Hovercraft Frame                            Hovercraft Bottom Skin

 


 

My Hovercraft: Part 1

The Frame

 

Garage Before Hovercraft

 

 

 

 

 

 

May 14th, 2006: Here we have the makings of a nice clean garage. Unfortunately it did not stay that way. You can notice the blueprints for the ribs (main structural supports) on the ground.

 

 

 

 

 

 

 

 

 

 

Hovercraft Blueprints

 

 

 

 

 

 

 

 

 

 

 

May, 2006: Here are the main blueprints for the hovercraft. The ones on the table are for making the fans and I have not gotten that far yet so they got folded back up. The ones on the wall are pretty much for making the entire thing along with with book on the table. They are rather complicated since you need those along with the one on the floor just to get all the measurements you need.

 

 

 

 

 

 

 

 

 

 

 

 

Rib 1

 

 

 

 

 

 

 

May, 2006: You can see on the ground the pieces for Rib #2, which is the second main structural support. On the table are my main tools. A palm sander, a jig saw, some clamps, a circular saw is on the ground and a miter saw is to the left out of the picture.

 

 

 

 

 

 

 

 

 

Rib 6

 

 

 

 

 

 

 

 

 

 

 

June, 2006: Here I am shaping part of Rib 6. I skipped a lot of parts for pictures because it gets pretty redundant after a while.

 

 

 

 

 

 

 

 

 

 

 

 

 

All Ribs Cut

 

 

 

 

 

 

 

June, 2006: All the pieces for the ribs all cut out. There are 7 all together. The main pieces for 2 and 3 are the two ones glued together. 6 is on the ground, 5 and 7 are off to the left and 4 as well as the rest of the pieces for the other ones are on the bookshelf. Now onto epoxying those pieces together.

 

 

 

 

 

 

 

 

 

Supporting the Ribs

 

 

 

 

 

 

 

June, 2006: Most of the ribs are put together except Rib 1 and my best bud John is helping put on little plywood pieces to help support the frame and keep it from falling apart.

 

 

 

 

 

 

 

 

 

 

Ribs Standing

 

 

 

 

 

 

 

 

August, 2006: All the frame pieces are finally finished (still except Rib 1)and put together. Here they are aligned and standing (supported by bricks) where they are going to be attached together with the stringers. Works best on a level surface, no a cracked garage floor. But whatever,  I can adapt.

 

 

 

 

 

 

 

 

Frame almost done

 

 

 

 

 

 

 

 

 

August, 2006: Most of the stringers have been put into place. Rib 1 is finally finished not that I know what to do. The stringers would not bend down to Rib 1 so I spent about a week slowly bending it with clamps, bricks and duct tape. Shown here is the two upper stringers and I'm using the clamps to try and reach the back supports and holding it onto Rib 1 until I can cut the proper slots for it to fit in.

 

 

 

 

 

 

 

 

Frame Finished

 

 

 

 

 

 

 

August, 2006: The final finished frame. On to skinning it now.